To install the fittings correctly, it is necessary to do a good job of matching between the various components, the size is the same, such as various wire clamps for installing wires, various hanging rings that form insulator strings, various crimping pipes for connecting wires, repairing pipes, and pole towers. Various types of pull wire fittings, various types of spacer rods on sub-conductors, protective fittings used to protect conductors, etc.;
1. When installing, first pass the pre-twisted wire through a certain tool, then make it parallel to the wire, and then make a more obvious mark on the colored place of the pre-twisted wire (this is more conducive to better installation );
2. After finishing, calibrate the mark on the pre-twisted wire with the mark on the wire. Note that the tension part of the pre-twisted wire must be calibrated towards the direction of the tower;
3. After completion, you can directly wind the other section, and then use both hands to wind the end twisted wire in place;
4. In order to ensure the grip strength of the tension clamp, ensure that the twisted wires do not cross, and at the same time, ensure that the gap between them is relatively uniform before completing the installation;
In fact, it is very simple. The entire process only needs to be installed correctly step by step according to the instructions.
